Installation instructions
This board does not have an SD card slot.
This makes initial install relatively tricky.
Installing to SPI (recommended)
For now, this is left undocumented as this requires either doing it from an operating system, writing it from the vendor's U-Boot build, or using the tethered USB boot protocol.
In the future, a tethered USB boot install method will be made available.
Installing to shared storage (not supported)
There is no reason to install to shared storage. This board was designed to work with firmware installed to dedicated storage.
To install, you will need to figure out a way to write the shared disk image to the eMMC.
Device-specific notes
(No device-specific notes available)