Tow-Boot

PINE64 A64-LTS

Manufacturer
PINE64
Name
A64-LTS
Identifier
pine64-pineA64LTS
SoC
allwinner-a64
Dedicated firmware storage
yes
Architecture
aarch64-linux
Source
Tow-Boot repository
Links
Product page

Installation instructions

Installing to SPI (recommended)

By installing Tow-Boot to SPI, your PINE64 A64-LTS will be able to start using standards-based booting without conflicting with the operating system storage.

To do so, you will need to write the SPI installer image to an SD card.

 # dd if=spi.installer.img of=/dev/XXX bs=1M oflag=direct,sync status=progress

Once done, start the system, and in the boot menu, select “Flash firmware to SPI”.

Once this is done, remove the installation media, and verify Tow-Boot starts from power-on.

Installing to shared storage

Using the shared storage strategy on the PINE64 A64-LTS can be done by writing the shared.disk-image.img to an SD card or eMMC.

 # dd if=shared.disk-image.img of=/dev/XXX bs=1M oflag=direct,sync status=progress

Device-specific notes

(No device-specific notes available)